Adhesive Labels

A4 Adhesive Label Sheets, 9 Layouts

A4 Label Sheets

Genuine Products
7×12 Support
Fast Delivery
One-Year Warranty

ModelLABEL-A4

Get a Quote Call Us

Before we quote, please share: label material, operating temperature, print content, daily volume and current device model.

Key Advantages

Why Choose This Product

Designed for shop-floor, warehouse and retail environments, balancing print quality, system integration and long-term cost.

No barcode printer|runs on the office printer 9 layouts|full sheet to 4-up, pick per job Three facestocks|gloss, matte and kraft Short runs|one pack, no setup cost

Overview

A4 label sheets are flat stock printed on the office laser or inkjet printer you already own, with no barcode printer needed. They suit small, occasional jobs: a handful of cartons to mark, a batch of sample numbers before a trade show, a few asset labels at short notice.

Nine layouts

Standard 210x297mm sheet. The full sheet is uncut for your own trimming; 2-up is 210x148.5mm halves; 3-up is 210x99mm; 4-up is 105x148.5mm quarters. Facestock comes in gloss, matte and kraft: gloss gives the brightest colour, matte avoids glare and scans more reliably, kraft suits a natural or eco packaging look.

Laser versus inkjet

Laser fuser rollers run hot. If the adhesive cannot take that heat it creeps out from the label edge during a long run and gums the roller, so pick a heat-resistant adhesive for laser use. With inkjet the ink matters: pigment ink resists water and matte stock dries fast with crisp edges, while dye ink smears when wet unless laminated.

When not to use A4

Cost per label is higher than roll stock, so it loses on volume, and the die layouts are fixed. Past a few hundred labels a month, rolls on a barcode printer are cheaper.

Technical Specifications

Basic Specifications

Type：A4 adhesive label sheet Sheet size：210x297mm Layouts：full sheet, 2-up, 3-up, 4-up Label sizes：2-up 210x148.5mm; 3-up 210x99mm; 4-up 105x148.5mm Facestock：gloss, matte, kraft Packaging：flat sheets, sold by pack Printer：laser or inkjet office printer Typical use：short runs, samples, office marking

Applications

Office marking|cabinets, archive boxes, asset numbers Short runs and samples|trial labels without die tooling Occasional shipping|temporary address and courier labels Sample numbering|trade show and sample book IDs

Gallery

FAQ

Will laser printing cause adhesive bleed?|The fuser runs hot and a low-temp adhesive can creep from the edge and stick to the roller. Use the heat-resistant version and test one sheet first. Does inkjet ink smear?|Pigment ink on matte stock gives the crispest result. Dye ink smears when wet, so choose pigment ink or laminate if the label needs water resistance. Can the labels be peeled and re-applied?|Standard stock uses permanent adhesive and will leave residue if lifted whole. Ask for the removable version if it must be repositioned. Can I trim the full sheet myself?|Yes, with a trimmer along the edge. For exact sizes and clean edges, order the 2-up, 3-up or 4-up die-cut layouts instead.